Boot Loop 886x590 1 Full Fix: Windows 10 Boot Loop After Update 3

Full Fix: Windows 10 Boot Loop After Update

How do I repair a boot loop after a Windows update?


Boot loops in Windows 10 can be very problematic and prevent you from accessing Windows. Talking about boot problems, here are some common problems reported by users:

Windows 10 loop reboot – this is a relatively common problem and is usually caused by a problematic update. If you experience this problem, just delete the update that is problematic and install it again.
Windows 10 Boot Loop After Reset – Sometimes, you might be stuck in the boot loop because of your driver. Unchecked drivers can cause this problem, and to fix the problem, you need to update it and check whether it helps.
Windows 10 Continuous reboots – sometimes, this problem can occur if you experience problems with damaged system files. However, you can fix it only by running multiple commands in the command prompt.
Windows 10 Boot Automatic Repair Loop – Your BIOS settings can also cause this problem to appear. Some users report that the safe boot feature causes this problem, and to fix it, you only need to deactivate this feature.
Windows 10 Boot Blue Screen Loop, Black Screen, BSOD – Sometimes, a blue screen can appear and force your PC to restart. To fix it, you must write an error message and do a little research to see how to fix the problem correctly.

Make sure your drivers are the latest

You are stuck in a boot loop; the problem might be your driver. According to users, the updated drivers can cause this problem to appear, and to fix it; you need to update your driver to the latest version.

This problem is usually caused by a graphics card driver, but your hard drive or SSD driver can cause this problem too.

To be on the safe side, it is recommended to update as many drivers as possible and check whether it solves the problem.

Use the command prompt

  • Reactivate your PC several times during the boot sequence.
  • Now go to Troubleshooting> Advanced Options> Prompt command.
  • When the command prompt is open, enter the following command:
C:
CD WindowsSystem32Config.
MD backup.
Copy *. * Reserve
Regbace CD.
Copy *. * …
  • Sometimes you can find a loop boot because the system file is damaged. However, there are ways to fix this problem. Windows makes a copy of a particular system file, and if something goes wrong, you can easily restore your system file.
  • When prompted to overwrite the file, just press the A button and then press ENTER. After the process is complete, type out, and the problem must be resolved.

Use safe mode

  • Let your PC restart several times during the boot sequence.
  • Now you must be served with an options list. Select Break Problems> Advanced Options> Startup settings from the menu. Now click Restart to continue.
  • After your PC restarts, you will be served with a list of options. Select Safe Mode with the network by pressing the appropriate button on your keyboard.
  • If you are stuck in a boot loop on your PC, you might be able to solve the problem just by using Safe Mode. As you know, Safe Mode is a special segment of Windows that runs with the default settings, and if you have a problem with Windows, Safe Mode is the perfect place to start problem-solving.

After you enter safe mode, check whether the problem is still there. If the problem does not appear in safe mode, you can use Safe Mode to solve the problem further.

Leave a Comment

Your email address will not be published. Required fields are marked *